Search 650Rider.com and XS650.com using Google!
|
 | |
|
|
xs650 > > High Performance Modifications > > All the rest > > clutch cable adjustment |
---|
Author |
Message |
BklynMatt Full Member


Joined: Sep 21, 2008 Posts: 23
|
Posted: November 17, 2009, 10:05 am Post subject: clutch cable adjustment |
|
Because Murphy was beside me (and my haste to reassemble) when I gasketed & applied silicone sealant to my engine left side case cover. I had connected theClutch Cable on the lower end, without attaching the handlebar end. when I attempted to do this I did not have enough cable to attach.(after adjusting the slotted screw & knurled thumb wheel all the way down). Now This is the cable which came off. I'm thinking the end inside the case is in a position which is the cause of this. Now I haven't adjusted the double screw at the case but I'm not expecting a good result when I do.
Now my question is, will I have to drain the oil before removing this case cover? I don't believe this is a wet case, It is gasketed, but its open for the Chain to round the sprocket,
any thoughts on either of the problems I am having?
1- the Cable length
2- oil drain requirement
|
|
Back to top |
|
 |
rtaylor522 Full Member


Joined: Feb 12, 2009 Posts: 69 Location: Gorgeous Prince Georges MD
|
Posted: November 17, 2009, 11:01 am Post subject: Re: clutch cable adjustment |
|
Hey there, It's been awhile since I've adjusted the clutch cable but I'll give it a whirl for you:
1st, you don't have to drain the oil to pull the left side case. just remove the allen bolts and remove the cover.
2nd, if you attach the cable at the top, then run it to the left side case and attach to the worm gear, I believe since the worm gear is spring loaded you actually do have a little bit of pull on it all the time (just not enough that it's engaging the push rod.)
(I don't have my manual in front of me here now so someone corrct if I'm wrong)
I believe you loosen the lock nut and turn the srew in all the way (until it just starts to get tough to turn...don't force it) then turn it back a quarter of a turn and lock it down.
then go to the handle bar adjustment and adjust it so there is just maybee 1 or 2 mm of play up there.
This should get you going, then I believe I've read that you should'nt do the final adjustments until the engine is hot, so go ride around and re-adjust as necessary
Someone else feel free to jump in because it's been atleast 3 years since i've done this
-Rob
_________________ 1972 XS2 |
|
Back to top |
|
 |
despecial Full Member


Joined: Sep 26, 2009 Posts: 232 Location: D20000
|
Posted: November 17, 2009, 11:15 am Post subject: Re: clutch cable adjustment |
|
- if you had your worm drive apart to inspect for cracks, clean and grease it as you should you may have put it together wrong...it can enter all splines but only 1 gives the correct position
- remove LHS case - no need to drain oil
- make sure the ball bearing goes back in too
- also to adjust
..wind handlebar adj all way in
..fit cable - inspect, clean and lubricate first
..back off lock nut under the small round worm cover, LHS
..adj screw to quarter turn freeplay
..adj handlebar to quarter inch freeplay
...readjust after 20 mins as motor expands and mucks up your cold adjustment
_________________ Most motorcycle problems are caused by the nut that connects the handlebars to the saddle. |
|
Back to top |
|
 |
BklynMatt Full Member


Joined: Sep 21, 2008 Posts: 23
|
Posted: November 18, 2009, 9:11 am Post subject: Re: clutch cable adjustment |
|
Thank You both,
for replying to my problem.
Sincerely
Matt D.
|
|
Back to top |
|
 |
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum
|
|
|
|
|
Check out the new Honda CB750 Forum at CB750.com! A site dedicated to the great Honda SOHC and DOHC CB750.
Check out the new Yamaha XS400 Forum at XS400.com!
Yamaha xs650
xs650, xs, 650, forum, links, chopper, custom, yamaha, parts, forum, info,
information, bb, bulletin board, XS650 650Rider, Free Unrestricted xs650
forum, Personal photo albums, Post images in Forum, News columns, Daily blog,
Links, Event calendar, Information for Yamaha XS650
Interactive software released under GNU GPL,
Code Credits,
Privacy Policy
|